DS200TBPAG1A - PLU Termination Board

DS200TBPAG1A - PLU Termination Board DS200TBPAG1A - PLU Termination Board

World Of Controls understands the criticality of your requirement and works towards reducing the lead time as much as possible.

DS200TBPAG1A - PLU Termination Board is available in stock which ships the same day.

DS200TBPAG1A - PLU Termination Board comes in UNUSED as well as REBUILT condition.

To avail our best deals for DS200TBPAG1A - PLU Termination Board, contact us and we will get back to you within 24 hours.


Part No.: DS200TBPAG1A
Manufacturer: General Electric
Product Type: PLU Termination Board
Series: Mark V

DS200TBPAG1A is a PLU Termination Board developed by GE under the Mark V series. The board is for Low Level Signals EX2000 and mark V. It was made to fit into a later Speedtronic system that GE distributed and was intended for the control of gas and steam turbines. The MKI marked the beginning of the Speedtronic range, which was developed during the 1990s. While MKV components are no longer sold by GE, they are still accessible through WOC as fully inspected and optimized refurbished hardware. Please be aware that the DS200 series boards do not come with updated firmware; if this is required for your system, look for boards from the corresponding DS215 series.

DS200TBPAG1A Features

  • This circuit board is long and narrow, with two back-to-back lines of four terminal strips on one side. The circuit board contains seven transistors, six vertical pin cable connectors, seven resistor network arrays, and twelve jumper switches. The board has various capacitors, resistors, and diodes, as well as 24 metal oxide varistors. On board components, reference designators and/or original manufacturer codes are frequently seen. The board has been drilled with a minimum of three holes. These drill holes are encased in a conductive material.
  • It frequently functions as part of the EX2000 excitation system. This circuit board is both long and narrow, with four terminal strips arranged in two back-to-back lines on one side. The board also features twelve jumper switches, seven resistor network arrays, and six vertical pin cable connectors.
  • Typically, reference designators and/or the codes from the original manufacturer are stamped on board components. Three holes are drilled into the board. A conductive substance surrounds these drill holes.
  • More details can be found in technical support materials from General Electric like data sheets, user guides, or product manuals. Please read and abide by all safety instructions for your own protection.

The most extensive assortment of GE Speedtronic Mark V control replacement components can be found at World of Controls. Our experts are here to assist you with your Mark V requirements at any time. Please contact WOC if you require any additional information.


Frequently Asked Questions


What is DS200TBPAG1A?
DS200TBPAG1A is a PLU Termination Board developed by GE under the Mark V series.

How to Obtain DS200TBPAG1A?
WOC provides DS200TBPAG1A as well as other turbine control products. Contact World of Controls.