IS200BAPAH1A - Analog Processor with Terminal Board

SPECIFICATIONS

Part Number: IS200BAPAH1A
Manufacturer: General Electric
Series: Mark VIe
Product type: Excitation Regulator Converter
Availability: In Stock
Country of Manufacture: United States (USA)

Functional Description

IS200BAPAH1A is a Analog Processor developed by GE. It is a part of Mark VIe control system. The component pressure inputs and sensor power outputs can be used with non-sparking (nA) devices when properly wired in Class I Division 2 or Zone 2.

Features

The analog processor includes the following features:

• Eighteen analog signal-conditioning channels
  
  • Differential inputs
  • Adjustable gains of 1x, 2x, 4x, and 8x
  • Dc bias nulling
  • Multiplexer to bypass signal input and apply test signal
  • Anti-alias filters to support 5 kHz bandwidth
• Twenty-four A/D input channels
  
  • Six channels per converter
  • 16-bit converter
• Application FPGA
  
  • A/D converter control
  • D/A converter control
  • Eighteen channels of FIR filtering
  • Configuration registers
  • HSSL control
• Boots FPGA with programmable read-only memory (PROM)
  
  • Bootstrap function
  • TX / RX mini-MACs
  • PHY sync
• PHY0 and PHY1 physical Ethernet layers
• Power supplies
  
  • P28 input
  • P15 and N15 outputs
  • P5 output
  • 3.3 V, 2.5 V, and 1.2 V outputs

LEDs

• When 28 volts of power is present, PWR displays solid green.
• When powered on, ATTN will display solid red for about a half second before going dark. If a valid serial link with the host UCSA is established, configuration will be downloaded to the BAPA, and the LED will turn solid green.
• If the high speed serial link interface on the BAPA has established a proper link with a UCSA serial port, the link displays solid green.
• Tx/Rx represents packet traffic on a high-speed serial link. When this traffic is present, this LED will blink green.

Replacement Procedure

1. Isolate the power source and lockout/tagout the field equipment.
2. Unplug the HSSL Ethernet cable from the to-be-removed module. Remove any cord ties that are holding the cable to the module.
3. Remove the BAPA module by unscrewing the retaining hardware.
4. Insert the new module into the old module's location and securely tighten the retaining hardware.
5. Connect the HSSL Ethernet cable to the module and secure it.

WOC is happy to assist you with any of your automation requirements. Please contact us by phone or email for pricing and availability on any parts and repairs.

FREQUENTLY ASKED QUESTIONS

What is IS200BAPAH1A?
It is a Analog Processor developed by GE

What are non-sparking (nA) devices?
Non-sparking (nA) devices are devices that are designed to prevent the ignition of flammable substances in hazardous environments. They are commonly used in industries such as oil and gas, chemical, and mining.

What is Class I Division 2 or Zone 2?
Class I Division 2 and Zone 2 are hazardous location classifications used to designate areas where there may be flammable gases, vapors, or liquids present. Devices used in these areas must meet certain safety standards to prevent ignition of the hazardous materials.

What does a solid green PWR display mean?
When 28 volts of power is present, PWR displays solid green.

What does a solid red ATTN display mean?
When powered on, ATTN will display solid red for about a half second before going dark.