DS3800HLSD1A1A - Data Link Slave Interface Board

DS3800HLSD1A1A - Data Link Slave Interface Board DS3800HLSD1A1A - Data Link Slave Interface Board

World Of Controls understands the criticality of your requirement and works towards reducing the lead time as much as possible.

DS3800HLSD1A1A - Data Link Slave Interface Board is available in stock which ships the same day.

DS3800HLSD1A1A - Data Link Slave Interface Board comes in UNUSED as well as REBUILT condition.

To avail our best deals for DS3800HLSD1A1A - Data Link Slave Interface Board, contact us and we will get back to you within 24 hours.


Part Number: DS3800HLSD1A1A
Manufacturer: General Electric
Series: Mark IV
Product Type: Data Link Slave Interface Board
Number of channels: 12
Input Voltage Range: 24 V dc
Operating temperature: -40 to +85°C
Size: 8.25 cm high x 4.18 cm
Repair: 3-7 Day
Availability: In Stock
Weight: 2 lbs
Country of Origin: United States


DS3800HLSD1A1A is a Data Link Slave Interface Board manufactured and designed by General Electric as part of the Mark IV Series used in GE Speedtronic Control Systems. is an advanced EtherCAT Slave Controller device used for EtherCAT communication. It provides the interface for data exchange between the EtherCAT master and the slave’s local application controller. The X-gateway's primary function is with the fast transfer of cyclic I/O data between the two networks. This offloads your PLC from working with additional calculations. The gateway acts as a Master on the PROFIBUS network and a Slave on the CC-Link network. The data transmission is completely transparent with a maximum data capacity of 512 bytes in each direction.


  • Multi-function control and IO block with 24 configurable IO ports for real-time IO functions (GPIOs, PWM, Step/Direction, I2C, SPI, DAC, incremental encoder)
  • High voltage IO block with 8 short circuit protected push-/pull or open drain high voltage I/Os for up to 24V and 100mA drive current.
  • Two integrated 500mA step-down switching voltage regulators with one being fixed at 3.3V and one being programmable between 5V and 24V.
  • Two integrated 100-MBit Ethernet PHYs to directly connect to twisted pair copper or back-to-back directly to another PHY
  • Simple configuration of EtherCAT Slave Controller and Multi-Function Control and IO block via EEPROM
  • Single supply architecture depending on application: 3.3V only or 5V to 35V (5V, 12V, or 24V typical)

WOC has the largest stock of GE Speedtronic Control System Replacement Parts. We can also repair your faulty boards. WORLD OF CONTROLS can also supply unused and rebuilt backed-up with a warranty. Our team of experts is available round the clock to support your OEM needs. Our team of experts at WOC is happy to assist you with any of your automation requirements. For pricing and availability on any parts and repairs, kindly get in touch with our team by phone or email.


What is a Data Link Slave Interface Board?

A Data Link Slave Interface Board is a device designed to facilitate communication between different devices or systems. It typically serves as a slave node in a data link network, allowing for the exchange of information with a master node or other devices on the network.

How does the Data Link Slave Interface Board work?

The board works by receiving and processing data from a master node or another source on the data link network. It interprets the incoming signals, performs any necessary tasks or computations, and may respond accordingly.

What types of interfaces does the Data Link Slave Interface Board support?

The supported interfaces can vary based on the specific board, but common interfaces include RS-232, RS-485, UART, SPI, I2C, and others depending on the application requirements.