[email protected]
+1 832 946 3166
Instagram

Is200stcih1a

IS200STCIH1A - MARK VI GE DIN RAIL CONTACT INPUT CARD

IS200STCIH1A - MARK VI GE DIN RAIL CONTACT INPUT CARD IS200STCIH1A - MARK VI GE DIN RAIL CONTACT INPUT CARD

World Of Controls understands the criticality of your requirement and works towards reducing the lead time as much as possible.

IS200STCIH1A - MARK VI GE DIN RAIL CONTACT INPUT CARD is available in stock which ships the same day.

IS200STCIH1A - MARK VI GE DIN RAIL CONTACT INPUT CARD comes in UNUSED as well as REBUILT condition.

To avail our best deals for IS200STCIH1A - MARK VI GE DIN RAIL CONTACT INPUT CARD, contact us and we will get back to you within 24 hours.

Request For Quote
Contact Us

Featured Product

SPECIFICATIONS

Part No.: IS200STCIH1A
Manufacturer: General Electric
Product Type: Terminal Board
Series: Mark VI

IS200STCIH1A is a DIN RAIL Contact Input Card under GE Mark VI. This system was one of the final Speedtronic steam or gas turbine management systems to be introduced by GE. The Speedtronic line, which began with the Mark I in the 1960s and ended with the Mark VI and Mark VIe in the 1990s, contained numerous systems.

  • The Mark VI is commonly powered by a 125 V dc battery system with external short circuit protection. The system can be powered from a 120/240-volt source and rectified to 125 volts dc using a power converter.
  • The IS200STCIH1A is a tiny board with a limited component selection.
  • A single female 37-pin (D-type) connector is positioned in the center of one of the board's long edges.
  • A two-level terminal strip with fifty-one connections runs along the board's other long edge. This is referred to as TB1. A three-position female plug is situated behind the terminal strip on the board.
  • There is only one integrated circuit in the IS200STCIH1A. (U1.) It has about 80 resistors, several diode lines, and various capacitors.
  • Small drill holes are located one per corner, two-terminal holes (E1/E2) are located at the end of the terminal strip, and two larger holes are made in the PCB's surface.
  • These can be found on each of the short edges. Codes 3212, Type 6, and FA/00 are stamped on the component. The board number can be found in two places on the board's surface.

The most extensive assortment of GE Speedtronic Mark VI control replacement components can be found at World of Controls. Our experts are available to assist you with your Mark VI requirements at any time. Please contact WOC if you require any additional information.

 

Frequently Asked Questions

 

What is IS200STCIH1A?
IS200STCIH1A is a DIN RAIL Contact Input Card under GE Mark VI series.

What are the components on IS200STCIH1A?
The board has a single integrated circuit and has over eighty resistors, many lines of diodes, and several capacitors.

How to Obtain IS200STCIH1A?
WOC provides IS200STCIH1A as well as other turbine control products. Contact World of Controls.