DS200KLDCG1A - KEY/LED/DISPLAY CARD

SPECIFICATIONS

Part Number: DS200KLDCG1A
Manufacturer: General Electric
Product Type: Key/LED/Display Card
Series: Mark V
Availability: In Stock
Country of Origin: United States of America (USA)

DS200KLDCG1A is a Key/LED/Display Board manufactured by General Electric as part of the Mark V Series used in gas turbine control management systems.  It has 32 LEDs, 21 4-character displays, and one jumper. On the back of the board, there is also a 40-pin connection strip. The 4-character displays, as well as the 32 LEDs, are used to display information about the drive's operation. As a result, the board is installed in a location on the drive where the operator can see it. The nomenclature DS1-DS32 is used to identify each LED on the card. Two wires connect to the board via the L1 part.

DS200KLDCG1A Features

• The board measures 8.5 inches by 11 inches and has holes in all four corners. Several aspects of the board must be considered before installing the drive. First, take note of where the original board is installed and whether or not screws are used to secure it. Make sure you have a screwdriver on hand to loosen and remove the screws.
• Take note of any cables that are attached to it. Attach a small strip of paper or a tag to the cables that indicate which connector the cable is connected to. The connectors are all labeled with an identifier, which you should write down on the tag.
• Take note of which pins on the jumper are covered. Before installing the replacement, place the jumper over the same pins as the old board to ensure that the board is configured correctly. Remove the four screws from the old board with the screwdriver. Keep the four screws and any washers that were attached together.
• Screws are inserted into the four holes in each corner of the board to secure it to the drive cabinet. The holes line up with the screw holes in the drive's cabinet rack. Before you remove the faulty board, take note of where it is installed and how the cables are routed in the cabinet.
• Cable routing is important because it protects the drive from high-voltage current interference caused by a signal cable that is too close to a high-voltage cable. Additionally, cable routing aids in maintaining proper air flow. Improper cable routing may obstruct airflow and cause components to overheat.

WOC has the largest stock of Speedtronic Mark V control spares. Our team of experts is available round the clock to support your needs. Our sales team at WOC is happy to assist you with any of your automation requirements. Please contact our staff by phone or email for pricing and availability on any parts and repairs.

 

FREQUENTLY ASKED QUESTIONS

 

What is DS200KLDCG1A?
The DS200KLDCG1A is a Key/LED/Display Board that features One jumper, 32 LEDs, and twenty-one 4-character displays.

How many pins do the KPL connections on the board have?
The KPL connections on the board, also known as connections 1KPL-3KPL, are 8-pin connectors for the display board. These connections are located at the top of the device, pointing outwards.

How many LEDs are there on the board?
It has a total of 32 LEDs. The LEDs are organized in four rows of eight and are labeled DS1-DS32.

How much power does the module's battery provide?
The two batteries labeled C92 and C93, provide +35 VDC.

How many pins is the 3PL connector?
The 3PL connection strip has 40 pins. This connection is located on the top right-middle side.

How to Check Price and Availability For Display Board?
Please Contact World of Controls FZE for sales at +1 609 385 1231 or Request a Quote.